doCmdEnterReceiveLoop

int doCmdEnterReceiveLoop(void)

Parameters

None.

Return Value

CANAL_ERROR_SUCCESS on success or an error code on failure.

Description

This command sets an open interface in the receive loop (RCVLOOP) state. It does nothing other then putting the interface in the loop mode and checking that it went there.

Note! The only way to terminate this receive loop is to close the session with doCmdClose (or just close the socket) or send the doQuitLoop command doCmdQuitReceiveLoop.

See Also

doCmdQuitReceiveLoop


Very Simple Control Protocol
This document is licensed under Creative Commons BY 4.0 and can be freely copied, redistributed, remixed, transformed, built upon as long as you give credits to the author((s).

results matching ""

    No results matching ""